C/p

If you are using DN equipement the Ipro 2000 will autodetct your settings.

Download unzip and copy latest bin to your USB Flash Drive. All files are named Up.hzf, do not change the name.

To check if loaded and what version software you have in:
Menu Installation Receiver Information

To Factory Default
Menu Installation Factory Default

Installation
Turn on reciever
Plug in USB Flash drive
Menu should be up choose Installation
Upgrade by USB
On the bottom you will see two buttons OK and Cancel. Highlight OK button and press Enter Key on your remote to start the upgrade process. During the upgrade process a progress bar will appear on the bottom of the window showing you how much is done.
Let it load when it sais do you want to reboot press ok

Installation Wizard should come up after rebooting
Yellow Button Choose language
Yellow Button Set location
Yellow Button Enter Receiver Serial Number from bottom of receiver
Yellow Button Start auto set up press ok
Search Satellites
-Choose Echo 7 Blue botton when done Save press OK
-Choose Echo 8,10 Blue botton when done Save press OK
What ever other satellites you have
Exit to Quit
Put on a PPV channel 505 or 510 let it autoroll and you will be up and watching tv.

IKS Setup
Plug eathernet cable to your modem
Menu
STB Setup
Network Setup
Hit OK and make sure your ip shows up
Leave Cable in.

MANUAL SETUP FOR NON DN EQUIPMENT
Use the left and right arrows on the remote to look at each satellite in the Antenna Setup Screen.

The right-side of the screen shows if you have a lock on that satellite or not.

If getting "ghost" or "phantom" locks on satellites that you DON'T have set their LNBs to a lower frequency to get rid of the lock.

For Dave or Legacy LNBs set the LNB type to "Standard" and the frequency to "11250".

Set 22Khz and DiSEqC settings.
(You won't get a lock on 61.5 with the default transponder, but if you press the GREEN Button, you can cycle through the TPs and point to one that will show you a good lock on 61.5)

Once you have cycled through all of the satellites and have setup the 22Khz switches and DiSEqC settings and you are getting good locks on the ones you know you can lock and you are NOT getting any "ghost" locks.

Go down to the bottom of the screen and you can cycle through FOUR options: “SAT. Search Start”, "Multi SAT. Search Start", “TP Search Start” and “Network Search Start”.
Select “Multi SAT. Search Start”
Hit "OK" on the remote.

This brings up the "Select Satellite" Screen. Here you use your up / down arrows and "OK" on the remote to put check marks in the satellites that you want to scan.

Then use the right arrow key to highlight "Search Start" and hit "OK" on the remote. Scanning starts.

The "Save" is highlighted at this point.

Hit "OK" on the remote to exit scanning.

Exit out of install.