Here is a how-to installing adapter and module onto your SONICVIEW SV-HD8000

1) Turn OFF the receiver and unplug the power from the outlet

2) Unscrew 5 screw (2 on each side, and 1 in the back) to remove the case cover

3) Remove the module bracket

4) Remove the sticker in the rear

3) Connect 2 cables to the sub-board

4) Connect the sub-board to the module .
Please be careful that Parts mounted surface should be up.

5) Connect LNB Power cable from the power supply board to the sub-board connector.

6) Connect the cable with the smaller connector from the sub-board to the connector of PCB
Please make sure the red cable should be in #1 pin.

7) Fit the module thru the hole(reserved for the UHF remote antenna)in the rear of the receiver tight it up using nut & washer

8) Connect a loop thru cable connecting the IF Output and the module input